TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 152 of 1008

TM 9-2350-261-20-2

REPLACE GENERATOR DRIVE BELTS (100 AMP GEN ONLY) — Continued

0226 00

REPAIR OR REPLACEMENT

1.

Inspect drive belts. If either belt is worn or damaged, discard both old belts and install new ones.

INSTALLATION

NOTE

When replacing drive belts, replace in matched sets only.

1.

Install two new drive belts (1) on drive pulley (2) and generator pulley (3).

2.

Turn turnbuckle (4) and tighten belt until belt deflection at midspan is 1/2 to 5/8 inch (13 to 16 mm) when 25 lbs (11 kg)

of force is applied.

3.

Tighten locknut (5) on rod end (6).

FOLLOW-THROUGH STEPS

WARNING

Wearing loose clothing around moving parts can allow personnel to get caught and could result

in injury or death. Tuck in loose clothing.

1.

Start engine (see your -10).

2.

Stop/shutdown engine (see your -10).

3.

Install power plant rear access panels (WP 0431 00, WP 0432 00, and WP 0433 00).

END OF TASK

0226 00-2