TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 156 of 1008

TM 9-2350-261-20-2

REPLACE GENERATOR AND ADJUSTMENT LINKAGE (100 AMP

GENERATOR ONLY) — Continued

0227 00

INSTALLATION

NOTE

Ifinstallingnewgenerator

,beginwithStep1, but remove nut and washer from generator

shaft before installing pulley. Nut and washer are not used. If not installing new generator

go to Step 3.

1.

Install key (15) in generator shaft (14).

2.

Install bushing (13) and pulley (12) on generator shaft (14) with three washers (11) and screws (10). TORQUE

SCREWS TO 73-79 LB-IN (8-9 N·M).

3.

Place bracket (6) on engine. Secure with two straps (9), four screws (8), and new locknuts (7). Do not tighten.

4.

Install generator (1) on bracket (6). Secure with screw (5), screw (4), two washers (3), and new locknuts (2).

0227 00-4