TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 163 of 1008

TM 9-2350-261-20-2

REPLACE GENERATOR AND ADJUSTMENT LINKAGE (200 AMP

GENERATOR ONLY) — Continued

0228 00

11. Assemble fan drive tensioner (29) and install on bracket (15). Secure with pin (30) and two new cotter pins (31).

12. Place generator drive belt (1) on pulleys (2) and (3).

NOTE

Use straight edge across face of both pulleys to assist in proper alignment.

13. To obtain correct alignment, adjust the position of the generator mounting bracket (4) before you tighten the screws (5)

in the slotted holes. Align pulley (2) on generator (6), with drive pulley (3) on transfer gearcase, then tighten screws (5).

14. Turn turnbuckle (7) until belt deflection at midspan is 1/2-5/8 inch (13-16 mm) when force is applied.

022800-5