TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 636 of 1008

TM 9-2350-261-20-2

REPLACE LEFT FINAL DRIVE SHAFT — Continued

0348 00

4.

Remove yoke (4) from final drive (5).

5.

Remove four locknuts (9) and adapter (10) from differential (11). Discard locknuts.

INSTALLATION

1.

Secure adapter (1) to differential (2) with four new locknuts (3). TIGHTEN NUTS TO 75–80 LB-FT (102-108 N·M)

TORQUE. Use torque wrench.

2.

Install yoke (4) in final drive (5).

NOTE

When using torque wrench with torque wrench adapter, torque value must be corrected.

Procedure for converting torque value is in WP 0120 00.

3.

Position propeller shaft (6) in vise and install universal joints (7) with eight new screws (8) and washers (9). TIGHTEN

SCREWS TO 35–40 LB-FT (47–54 N·M) TORQUE. Use torque wrench and torque wrench adapter. LOOSEN

SCREWS, THEN TIGHTEN AGAIN TO 35–40 LB-FT (47–54 N·M) TORQUE.

0348 00-2