TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 467 of 779

Note.

Before installing assembled fuel in -

and accessory drive housing stamped number s

jection advance assembly and fan drive beve l

correspond to their proper location befor e

gearshaft, check gearshaft backlash and re-shi m

assembling .

as necessary (fig. 6-189). Be sure bearing ca p

Figure 6-206. Installing fuel injection advance bearing cap .

Section X. OVERHAUL OF CAMSHAFT AND THROTTLE CONTROL CROSS

SHAFT

AND

FUEL

INJECTION

PUMP

LINKAGE

6-43. General

procedures where applicable .

a.

This section covers the overhaul of th e

following

table (table 6-33 )

cam shafts and throttle control cross shaft and

illustration s

an d

instruction s

fuel injection pump linkage. Specific instruction s

operations .

Refer to th e

for applicabl e

for overhau l

on disassembly, cleaning, inspection, repair, and

b.

Overhaul of the right and left camshafts i s

assembly accompany the overhaul operations .

similar. For instructional purposes, procedure s

Overhaul standards of individual component s

for the right camshaft will be illustrated wit h

follow the inspection procedures. Stud iden -

references to the left camshaft only wher e

tification information is included in the repai r

overhaul procedures vary .

6-17 3