TM 9-2815-205-34
3-21. ROCKER ARM COVERS AND CRANKCASE BREATHERS REPLACEMENT (MODELS
5063-5392, 5063-5393, 5063-539F, AND 5063-539L) (Cont)
d. Assembly
(1) On models 5063-5393, 5063-539F, and
5063-539L, install oil filler cap (15) as
follows:
(a)
(b)
If removed, press strainer element
(18) into oil filler hole from bottom of
rocker arm cover (4) until flush with
bottom of bore. Stake strainer element
in position.
If removed, connect chain (17) to oil
filler cap (15) and to strainer element
(18) with two S-hooks (16). Crimp
S-hooks shut.
(2) On model 5063-5392, screw oil filler cap
(14) into rocker arm cover (4) until cap
clicks.
NOTE
●
On
models
5063-5393,
5063-539F, and 5063-539L
outlet from breather housings
point outboard.
(3)
(4)
3-72
●
On model 5063-5392, right
breather housing outlet points
towards front of engine and left
breather housing outlet points
towards rear of engine.
Install breather retainer (12) and filtering
disk (11) in breather housing (8).
Install seal (13), breather housing (8),
retainer (10), and three screws (9) in
rocker arm cover (4). Torque screws to
48-72 lb-in (6-8 N•m).
Change 1