TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992
TM-9-2815-205-34

  TM-9-2815-205-34 - Page 204 of 596

TM 9-2815-205-34
b. Cleanlng/Inspection
Dry cleaning solvent P-D-680 Is toxic and flammable. Wear protective goggles
and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and
clothes. Do not breathe vapors. Do not use near open flame or excessive heat.
The flash point is 100-138°F (38-50°C). If you become dizzy while using cleaning
solvent, get fresh air immediately and seek medical aid. If contact with eyes is
made, wash with water and get medical aid immediately.
Compressed air used for cleaning purposes wiII not exceed 30 PSI. Use only
with effective chip guarding and personal protective equipment (goggles/shield,
gloves, etc.)
(1) Clean rocker arm covers and oil filler cap with cleaning solvent and dry with compressed air.
Inspect caps and covers for cracks, dents, or other damage.
(2) Clean filtering disk with cleaning solvent and dry with compressed air.
c. Installation
(1)
(2)
(3)
Install inner screen (8), filtering disk (9), and outer screen (8) in breather body of rocker arm
cover (2) (from inside cover). Install two retainers (7) over screen into holes in breather body.
NOT E
Breather cover outlet points toward rear of engine.
Place gasket (6) and breather cover (5) on breather body of rocker arm cover (2). Install clamp
(4) on breather cover and breather body. Tighten clamp.
If removed, install oil filler cap (10) on chain (12) with hook (11). Clip hook and install cap into
oil filler hole. Tighten cap.
NOT E
Right and left rocker arm covers are identical except for oil filler hole. Use same
procedure to install both covers.
Oil filter hole is located at left front rocker cover.
(4) Place gasket (3) and rocker arm cover (2) on cylinder head. Install four screw and clamp
assemblies (1) into each rocker arm cover. Tighten screws securely.
END OF TASK
3-75


Back to Top