TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 213 of 596
TM 9-2815-205-34
3-26. AIR INLET HOUSING REPLACEMENT (MODELS
This task covers: a. Removal
b. Cleaning
5063-5393 AND 5063-539L)
c. Installation
INITIAL SETUP
MODELS
5063-5393 5063-539L
TOOLS AND SPECIAL TOOLS
EXPENDABLE/DURABLE SUPPLIES
Cleaning solvent (App C, Item 9)
EQUIPMENT CONDITION
Tool kit, general mechanics (App B, Item 107)
Wrench, torque (App B, Item 116)
MATERIALS/PARTS
Para Description
3-3 Turbocharger removed
3-18 Fuel line clip removed
3-12 Mounting bracket removed
Screen, air inlet (App F, Item 150)
Lockwashers (App F, Item 99)
a. Removal
NOT E
Three air inlet housing to blower screws were removed during removal of fuel line clip
and air pump bracket.
(1) Remove four short screws (1), two mid-sized screws (2), three long screws (3), nine
Iockwashers (4), nine flat washers (5), air inlet housing (6), and screen (7) from blower (8).
Discard Iockwashers and screen.
(2) Remove transducer (9) from air inlet housing (6).
b. Cleaning
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles
and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and
clothes. Do not breathe vapors. Do not use near open flame or excessive heat.
The flash point is 100-138 Degrees F (38-50 Degrees C). If you become dizzy while
using cleaning solvent, get fresh air immediately and see medical aid. If contact
with eyes is made, wash with water and get medical aid immediately.
Compressed air used for cleaning purposes will not exceed 30 PSI. Use only with
effective chip guarding and personal protective equipment (goggles/shield,
gloves, etc.)
(1) Clean air inlet housing with cleaning solvent and dry with compressed air.
(2) Inspect transducer for damaged wires, connector, and threads.
3-8 4
Change 1
Back to Top
