TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 220 of 596

TM 9-2815-205-34

b. Disassembly

(1) Blower drive support assembly

(a)

(b)

(c)

(d)

Remove governor weight shaft and carrier assembly (14) from blower drive support

assembly (5) using pry bars if necessary.

Remove retaining ring (15) and thrust washer (16). Slide blower drive gear and shaft

assembly (17) from blower drive support assembly (5).

Remove cup plug (18) from blower drive support assembly (5).

Tap governor weight shaft bearing (19) from blower drive support assembly (5). If bearing

is a tight fit, place a spacer against bearing and press from drive support.

(2) Blower drive gear and shaft assembly

(a)

(b)

(c)

Support blower drive gear and shaft

assembly.

Place 1-1/8 inch diameter brass drift

on end of shaft (20) and press shaft

out of gear (21).

Remove key (22) from shaft (20).

3-91