TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 211 of 596

TM 9-2815-205-34

3-25. AIR INLET HOUSING REPLACEMENT (MODEL 5063-5392)

This task covers: a. Removal

b. Cleaning

c. Installation

INITIAL SETUP

MODELS

5063-5392

TOOLS AND SPECIAL TOOLS

EXPENDABLE/DURABLE SUPPLIES

Cleaning solvent (App C, Item 9)

EQUIPMENT CONDITION

Tool kit, general mechanics (App B, Item 107)

Wrench, torque (App B, Item 116)

MATERIALS/PARTS

Para Description

3-2 Turbocharger removed

3-17 Fuel line clip removed

3-11 Angle bracket removed

1

Screen, air inlet (App F, Item 150)

9

Lockwashers (App F, Item 99)

a. Removal

NOT E

Three air inlet housing screws were removed during removal of fuel line clip and air

pump bracket.

(1) Remove nine screws (1), nine Iockwashers (2), angIe bracket (3), air inlet housing (4), and

screen (5) from blower (6). Discard screen and lockwashers.

(2) If necessary, remove plug (7) and plug (8) from air inlet housing (4).

b. Cleaning

•

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles

and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and

clothes. Do not breathe vapors. Do not use near open flame or excessive heat.

The flash point is 100-138 Degrees F (38-50 Degrees C). If you become dizzy

while using cleaning solvent, get fresh air immediately and seek medical aid. If

contact with eyes is made, wash with water and get medical aid immediately.

•

Compressed air used for cleaning purposes will not exceed 30 PSI. Use only

with effective chip guarding and personal protective equipment (goggles/shield,

gloves, etc.)

Clean air inlet housing with cleaning solvent and dry with compressed air.

3-82

WARNING