TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 215 of 596

TM 9-2815-205-34

3-27. AIR INLET HOUSING REPLACEMENT (MODELS 5063-5395, 5063-5398, AND 5063-539F)

This task covers: a. Removal

b. Cleaning

c. Installation

INITIAL SETUP

MODELS

EXPENDABLE/DURABLE SUPPLIES

5063-5395 5063-5398 5063-539F

Cleaning solvent (App C, Item 9)

TOOLS AND SPECIAL TOOLS

EQUIPMENT CONDITION

Tool kit, general mechanics (App B, Item 107)

Para Description

Wrench, torque (App B, Item 116)

3-3 Turbocharger removed

3-19 Fuel line clip removed

MATERIALS/PARTS

1

Screen, air inlet (App F, Item 149)

5

Lockwashers (App F, Item 99)

a. Removal

NOT E

Right middle air inlet housing screw was removed during removal of fuel line clip.

(1) Remove two long screws (1), three short screws (2), five Iockwashers (3), five flat washers (4),

air inlet housing (5), and screen (6) from blower (7). Discard screen and Iockwashers.

(2) If necessary, remove plug (8) from air inlet housing (5).

b. Cleaning

Ž

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles

and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and

clothes. Do not breathe vapors. Do not use near open flame or excessive heat.

The flash point is 100-138 Degrees F (38-50 Degrees C). If you become dizzy

while using cleaning solvent, get fresh air immediately and seek medical aid. If

contact with eyes is made, wash with water and get medical aid immediately.

• Compressed air used for cleaning purposes will not exceed 30 PSI. Use only

with effective chip guarding and personal protective equipment (goggles/shield,

gloves, etc.)

Clean air inlet housing with fuel oil and dry with compressed air.

3-86

WARNING