TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 222 of 596

TM 9-2815-205-34

d. Assembly

(1) Governor weight shaft and carrier assembly

(a) Lubricate governor weight shaft (11) with engine oil and slide governor riser assembly (29)

over shaft with bearing end toward serrated end of shaft. Pack bearing (30) with grease.

(b) Using governor weight spacer (31),

press weight shaft (11) into carrier

(25). Spacer will properly position

carrier on shaft.

NOT E

Governor high speed weights

are identified by long cam arm

and low speed weights are

identified by short cam arm.

(c)

(d)

(e)

Place two low speed weights (26) on

opposite sides of carrier assembly

(25). Drive grooved end of two weight

pins (24) through larger hole in

carrier, through weight, and then

through smaller hole in carrier. Drive

knurled end of pin until groove is

clear of carrier assembly.

Install two retainer rings (23) on two

weight pins (24).

Install two high speed weights (27) in

same manner as installing low speed

weights (Steps (c) and (d)].

3-93