TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 239 of 596

TM 9-2815-205-34

3-35. OIL PUMP INLET TUBE REPLACEMENT (ALL EXCEPT MODEL 5063-5299) (Cont)

c. Installation

(1)

(2)

(3)

(4)

(5)

(6)

3-110

Install bracket (8), two bolts (21), four flat washers (20), two Iockwashers (19), and two nuts

(18) on bracket (17). Do not tighten nuts.

Loosely install bracket (17), flat washer (16), Iockwasher (15) and bolt (14) on inlet tube

assembly (3).

Install strainer (13), two Iockwashers (12),

and two bolts (11) on inlet tube assembly

(3). Torque bolts to 13-17 Ib-ft (18-23

N

.

m).

Install gasket (10), inlet tube assembly (3), two Iockwashers (2), and two screws (1) on lower

front cover (4). Loosely tighten screws.

Install two flat washers (7), two Iockwashers (6), and two screws (5) in bracket (8) at main

bearing cap (9). Torque screws (5) to 30-35 Ib-ft (41-47 N

.

m) and screws (1) to 13-17 Ib-ft

(18-23 N

.

m).

Torque bolts (21) to 15-19 Ib-ft (20-26 N-m) and bolt (14) to 13-17 Ib-ft (18-23 N

.

m).