TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 367 of 596

(h)

(i)

(j)

(k)

TM 9-2815-205-34

Place C-washer (44) in groove near end of shaft (32).

To draw bearing (33) into position, turn hex nut (42) until C-washer (44) butts up against

installer (38).

Remove bearing installer (38) assembly from cylinder block.

Repeat steps (a) thru (j) for remaining intermediate bearings (33).

(2) Install four camshaft end bearings (29

and 31) as follows:

(a)

(b)

(c)

(d)

(e)

(f)

(9)

(h)

(i)

block.

Insert pilot (28) in bore of cylinder

block. Use small diameter of pilot if

bearing has been installed. Use large

diameter if there is no bearing in

Insert support (45) in end bore at

opposite end of block.

Start unthreaded end of shaft (32) into

pilot (28) and push through block and

support (45).

Place end bearing (29 or 31) on

installer (38) and align notch in

bearing with pin on installer. Slide

bearing and installer on shaft (32).

Ensure notch in bearing is positioned

properly in bore as shown.

Place C-washer (44) in groove near

end of shaft (32). Pull shaft back until

C-washer butts against installer (38).

Place spacer (39) (if required), thrust

washer (40), flat washer (41), and hex

nut (42) over threaded end of shaft

(32).

To draw bearing (29 or 31) into

position, turn hex nut (42) until

shoulder on installer (38) butts up

against block bore.

Remove bearing installer (38)

assembly from cylinder block.

Repeat steps (a) thru (h) for

remaining end bearings.

3-237