TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 359 of 596

TM 9-2815-205-34

NOT E

After proper gaps have been obtained, do not tighten inboard main bearing bolts again.

(e)

Install eight main bearing bolts (6) with hardened washers (7) through outboard holes in

support (8) and into threaded holes in cylinder block. Torque bolts uniformly to 91-99 lb-ft

(124-134 N·m) starting with center caps-and working alternately towards both ends of block.

NOT E

If bearings are installed prop-

(10)

(11)

erly, crankshaft will turn freely

with all of bearing cap bolts

drawn to specified torque.

Rotate crankshaft one full turn to ensure

freedom of movement.

Measure Crankshaft End Play

(a)

(b)

Mount dial indicator (28) on rear of

cylinder block with indicator point

resting on rear face of crankshaft gear

(17).

Using large screwdriver between

main bearing cap and crankshaft

counterweight, push crankshaft

toward dial indicator. With constant

pressure on screwdriver, set dial

indicator to zero.

NOT E

If correct crankshaft endplay cannot be obtained with standard size thrust washers, use

0.005 or 0.010 inch oversize washers.

Insufficient end play can result from a misaligned rear main bearing or a burr or dirt on

inner face of one or more thrust washers.

(c) Force crankshaft in opposite direction and

be 0.004 to 0.016 inch with new parts and

END OF TASK

FOLLOW-ON MAINTENANCE

Para Description

3-50 Install cylinder kits (models 5063-5299, 5063-5398,

3-51 Install cylinder kits (models 5063-5392, 5063-5393,

note amount of end play on dial. End play

maximum of 0.018 inch with used parts.

and 5063-5395)

5063-539F, and 5063-539L)

must

Change 1

3-229