TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992
TM-9-2815-205-34

  TM-9-2815-205-34 - Page 366 of 596

TM
9-2815-205-34
3-54. CYLINDER BLOCK MAINTENANCE (ALL EXCEPT MODEL 5063-5398) (Cont)
d. Assembly
NOT E
•
Install camshaft intermediate bearings prior to installing camshaft end bearings and
press into cylinder block from outboard end of bore.
•
Notch in front end and front intermediate bearings is toward front of engine. Notch in
rear end and rear intermediate bearings is toward rear of engine.
•
Camshaft replacement bearings are available with either standard or oversized
outside diameter and standard or undersized inside diameters (see Table 3-11).
•
Camshaft bearing remover and installer set is designed for use with standard size
bearings. To remove and install undersize bearings, reduce outside diameter of pilot,
installers, and remover by 0.020 inch.
(1) Install four intermediate camshaft
bearings (33) as follows:
TABLE 3-11. CAMSHAFT BEARING COLOR CODE
(a)
(b)
(c)
(d)
Insert large diameter of pilot (28) in
camshaft end bearing bore in block.
Insert intermediate bearing (33) into
outboard end of camshaft bore.
Ensure notch is positioned properly in
bore as shown.
Start unthreaded end of shaft (32) in
pilot (28) and push shaft through
entire length of cylinder block bores.
Slide installer (37) on shaft (32) until
locating pin engages notch in bearing
(33).
Bearing
Position
End
Inter-
mediate
(e)
(f)
(g)
3-236
NOT E
Use J-7593-15 installer when
installing right front or left rear
intermediate
bearing. Use
J-7593-3 installer when install-
ing left front or right rear
intermediate bearing.
Slide installer (38) on end of shaft (32)
with large diameter inserted into end
of block bore.
Place spacer (39), thrust bearing (40),
flat washer (41), and hex nut (42) over
threaded end of shaft (32).
Brown Black Standard
Brown Yellow
Oversize
Orange Red
Standard
Orange Blue
0.010
Oversize
Inside
Diameter
Standard, 0.010, &
0.020 Undersize
Standard
Standard, 0.010, &
0.020 Undersize
Standard
Align shaft (32) and install C-washer (43) in groove in shaft adjacent to installer (37).
0.010


Back to Top