TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 362 of 596

TM 9-2815-205-34

3-54. CYLINDER BLOCK MAINTENANCE (ALL EXCEPT MODEL 5063-5398) (Cont)

(15) Remove eight camshaft bearings from cylinder block as follows:

(a)

(b)

(c)

(d)

(e)

(f)

(9)

(h)

NOT E

Camshaft bearing remover and installer set is designed for use with standard size

bearings. To remove and install undersize bearings, reduce outside diameter of pilot,

installers, and remover by 0.020 inch.

Insert small diameter end of pilot (28) in end bearing (29).

Insert small diameter end of remover (30) in end bearing (31).

Insert unthreaded end of shaft (32) into pilot (28) and through intermediate bearings (33).

Push end of shaft into remover (30) until shaft snaps into place.

Drive end bearing (31) out of cylinder block.

Repeat steps (a) thru (d) for two intermediate bearings (33).

Insert large diameter end of pilot (28) in camshaft end bore with bearing removed. Repeat

steps (b) thru (d) to remove end bearing (29).

Repeat steps (a) thru (f) for opposite cylinder bank.

Discard all bearings.

3-232