TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 364 of 596

3-54. CYLINDER BLOCK MAINTENANCE (ALL EXCEPT MODEL 5053-5398) (Cont)

TABLE 3-10. OVERSIZE CYLINDER LINER SIZE REQUIREMENTS

Liner

(A) Diameter

(B) Diameter

(C) and (D)

Oversize

Limits

Limits

Diameter Limits

0.010 in.

4.5295/4.5315 in.

4.4965/4.4980 in.

4.53665/4.36755 in.

(0.254 mm)

(115.05/115.10

mm)

(114.21/114.25 mm)

(110.91/110.93

mm)

0.020 in.

4.5395/4.5415 in.

4.5065/4.5080 in.

4.3765/4.3775 in.

(0.508 mm)

(115.30/115.35

mm)

(114.46/114.50 mm)

(111.16/111.19 mm)

(4) Check cylinder head contact area for

flatness with straight edge (34) and

thickness gage set. Measurements must

not vary more than 0.003 inch crosswise

and 0.006 inch lengthwise.

NOT E

Counterbore depth must be

0.300 to 0.302 inch and not

vary more than 0.0015 inch

throughout

circumference.

Counterbore surfaces must be

smooth and square with cylin-

der bore. There must not be

over 0.001 inch difference

between any two adjacent

cylinder counterbores when

measured lengthwise along

cylinder center line of cylinder

block. If difference is over

0.001 inch, do not reuse block.

(5) Using depth gage (35), measure cylinder liner counterbore depth.

3-234

TM 9-2815-205-34