TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 244 of 968

TM 9-2815-210-34-2-2

FRAME 15

CAUTION

1.

2.

3.

4.

GO

Do not turn reamer (1) to the left while reaming valve

guides (2).

Never force reamer into valve guide. Damage

to valve guide will result.

NOTE

Do this frame only for valve guides (2) that have been

changed.

Slowly turn 0.4392 to 0.4390-inch external diameter reamer (1) to the right

while pushing reamer lightly into valve guide (2) until reamer is all the way

through valve guide.

While turning reamer (1) to the right, pull it out of valve guide (2).

Measure inside diameter of valve guide (2) after reaming. If inside diameter

of valve guide (2) is less than 0.4388 inch, do steps 1 and 2 again. Make sure

you are using right size reamer.

If inside diameter of valve guide (2) is more than 0.4394 inch, knock it out.

Refer to frame 12.

Get a new valve guide and put it in.

Refer to frame 14.

Then do steps 1, 2 and 3 again with right size reamer.

TO FRAME 16

4-225