TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 235 of 968

TM 9-2815-210-34-2-2

FRAME 6

1.

Lay straight edge (1) along line A on gasket surface of cylinder head (2).

Using 0.005inch feeler gage, check that gasket surface of cylinder head (2)

is not more than 0.005 inch out-of-flat lengthwise. If gasket surface is more

than 0.005 inch out-of-flat lengthwise, get a new cylinder head.

2.

Lay straight edge (1) along line B on gasket surface of cylinder head (2).

Do step 1 again.

3.

Lay straight edge (1) along line C on gasket surface of cylinder head (2).

Do step 1 again.

GO TO FRAME 7

4-216