TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 236 of 968

TM 9-2815-210-34-2-2

FRAME 7

1.

2.

3.

4.

5.

Lay a straight edge (1) along line A on gasket surface of cylinder head (2).

Using feeler gage, check that gasket surface of cylinder head is not out-of-

flat crosswise.

If gasket surface of cylinder head (2) is more than 0.003 inch out-of-flat

crosswise, get a new cylinder head.

If gasket surface is out-of-flat by less

than 0.003 inch crosswise, tag cylinder head for resurfacing by reaching shop.

NOTE

Cylinder head (2) may have been resurfaced before. If

cylinder head was resurfaced before, amount of metal

machined off will be stamped on front of cylinder head

about 1/2 inch from gasket surface of cylinder head.

No more than 0.005 inch can be machined off. If 0.005

inch has already been machined off and cylinder head

needs resurfacing, get a new cylinder head.

Lay straight edge (1) along line B on gasket surface of cylinder head (2).

Do steps 1 and 2 again.

Lay straight edge (1) along line C on gasket surface of cylinder head (2).

Do steps 1 and 2 again.

Lay straight edge (1) along line D on gasket surface of cylinder head (2).

Do steps 1 and 2 again.

GO TO FRAME 8

4-217