TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 535 of 968

FRAME 3

1.

2.

3.

4.

5.

NOTE

This task is shown for engine LD-465-1. This task

is the same for all engines.

Stand a new transmission input shaft (1) on gear end on surface plate.

Put clutch disk (2) on splined end of input shaft (1) with long end of drive

hub toward surface plate.

Set up dial indicator (3) as shown.

Take measurements at various places around clutch disk (2). Measurements

should be made near center, inside, and outside diameters of disk facing.

Difference between readings in step 4 should not be more than 0.010 inch.

Throw away clutch disk (2) if readings are different by more than given limit.

GO TO FRAME 4

4-516

TM 9-2815-210-34-2-2