TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 538 of 968

TM 9-2815-210-34-2-2

c. Repair .

NOTE

Repair is limited to adjustment only. For en-

gines LD-465-1, LD-465-1C, and LDT-465-1C,

go to frame 1. For engines LDS-465-1 and

LDS-465-1A, go to frame 4. For engine

LDS-465-2 go to frame 6.

FRAME 1

1.

Place 0.3749 to 0.3751 inch thick by 13.000 inches dimeter spacer plate (1)

into flywheel assembly (2) used for bench testing.

2.

Place pressure plate (3) in place and screw in and tighten eight capscrews (4).

3.

Using prybar, push in on each clutch finger (5) and take out clutch release

lever spacer blocks (6).

GO TO FRAME 2

4-519