TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 539 of 968

TM 9-2815-210-34-2-2

1.

2.

3.

4.

5.

6.

7.

Set depth micrometer (1) to 1.705 inches.

Take off adjusting screw lockplates or loosen locknuts (2).

Using spanner wrench socket (3), turn release lever adjusting nut (4) until

micrometer (1) touches release lever (5) and micrometer anvil (6) touches

clutch spacer plate (7).

Do step 3 again for other three release levers (5).

When distance in steps 3 and 4 is 1.674 to 1.736 inches, heights of four release

levers (5) must be within 0.015 inch of each other.

Do steps 3 and 4 again if needed.

Put on adjusting screw lockplates or tighten locknuts (2).

GO TO FRAME 3

4-520