TM-9-2815-213-34
ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)
FEBRUARY 1972
TM-9-2815-213-34 - Page 68 of 192
*TM 9-2815-213-34
Figure 3-74.
Mounting plate and ball joint vise
installation.
Figure 3-75. Governor weight assembly removal/
installation.
Figure 3-76.
Governor shaft oil seals-
removal/installation
(14) and lockwashers (9) securing gear assembly
(1) to pump housing. Remove gasket (2).
(b)
Separate cover (15) and housing
from two dowels (4) to release two shafts (6 and
7) two gears (5). Discard gasket (8).
(c)
Remove ring dowels (3) from hous-
ing.
(d)
Remove inlet adapter (12) and ball
check valve elbow (11) from cover.
(5)
Governor Spring Pack Assembly
(fig.
B-17).
(a)
Cut seal wire (33) and remove cap-
screw seal (34).
(b)
Remove two capscrews (32), two cap-
screws (36), four lockwashers (31) and four flat
washers (30) securing assembly to pump hous-
ing. Discard gasket (28).
(c)
Remove spring pack assembly from
housing barrel.
(d)
Remove snap ring (27) from guide
and clip assembly (22).
(e)
Remove spring retainer (26), high
speed spring shims (25), and high speed spring
(24).
(f)
Remove idle adjusting screw (23),
adjusting screw washer (21), idle speed spring
(20), and plunger (19).
(g)
Remove pipe plug (35) from cover.
(6)
Tachometer Drive Assembly
(fig. B-27).
(a)
Remove two slotted-head screws (3)
securing tachometer cable drive adapter (1) and
cap (2) to pump housing.
(b)
Remove adapter, cap, gasket (2), and
shaft seal (5). Discard gasket.
(c)
Using a brass drift, as shown in figure
3-77, drive the assembled shaft (6), bearing
Figure 3-77.
Tachometer drive assembly-
removal/installation.
3-39
Back to Top
