TM-9-2815-213-34
ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)
FEBRUARY 1972
TM-9-2815-213-34 - Page 71 of 192
*TM 9-2815-213-34
1 Adapter bracket (11020392)
7 Fuel manifold hose (11020361-10)
2 Adapter ring assembly (11020532)
8 Fuel suction hose (110203613)
3 Coupling insert (110200539)
9 Fuel input hose (11020361-11)
4 Discharge fitting assembly (11020540)
10 Fuel pressure hose (11020361-14)
5 Leakage accumulator hose (11020361-10)
11 Fuel return hose (11020361-12)
6 Leakage accumulator hose (11020361-10)
Figure 3-79.
Fuel pump test stand equipment.
Gasket). Move depth gage to opposite side of carrier and
again measure to front cover gasket surface directly
across cover from previous measurement (do not turn
carrier or cover). Average these two measurements. This
procedure is necessary to determine uneven carrier wall
heights.
(c)
Position depth gage across carrier directly over
weight assist plunger. Measure
down to plunger.
(b)
Subtract second measurement from average
determined under (b) above. The result is the weight
assist protrusion. If weight assist protrusion is below
specifications, (0.840/0.860), add shims on reassembly.
If weight assist protrusion is above specifications,
remove shims or grind exposed end of weight assist
plunger.
(4)
Pump Gear Assembly
.
3-42
Back to Top
