TM-9-2815-213-34
ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)
FEBRUARY 1972
TM-9-2815-213-34 - Page 73 of 192
*TM 9-2815-213-34
Figure 3-81. Pump mounted on test stand.
(7)
Fuel Pump Housing
.
(a)
Perforn general inspection of housing and
components in accordance with paragraph 2-6.
(b)
Check front main shaft bushing for evidence of
seizure or burns.
(c)
Using an inside micrometer measure inside
diameter of bushing. If worn beyond 0.7525-inch replace
bushing.
3-105. Repair
a.
Fuel Shut-Off Solenoid Valve Assembly
. Repair
of the valve assembly is limited to general maintenance
repair procedures, paragraph 2-7, and replacement of
defective spared parts (appendix B).
b.
Fuel Pump Damper Assembly
. Repair of the
damper assembly is limited to general maintenance
procedures (para. 2-7), and replacement
of defective spared parts (appendix B).
c.
Mainshaft Cover and Governor Assembly
. Repair of
the assembly is limited to general main. tenance repair
procedures (para. 2-7), and replacement of spared parts
(appendix B).
d.
Pump Gear Assembly
. Repair of the gear assembly
is limited to general maintenance repair procedures
(para. 2-7), and replacement of spared parts (appendix
B).
e.
Governor Spring Pack Assembly
.
(1) Replace governor if worn beyond limits specified in
serviceability standards. Replace with plunger and lap to
fit with No. 80 fine grit lapping compound. Remove all
lapping compound from parts.
NOTE
PTG Governor Plungers are color coded. Red
represents size 0 (standard) and
3-44
Back to Top
