TM-9-2815-213-34

ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)

FEBRUARY 1972

  TM-9-2815-213-34 - Page 75 of 192

*TM 9-2815-213-34
Figure 3-83. Pump preparation for test and calibration.
(10)Brush plunger lightly with crocus cloth to remove
any lubricant.
(11)If lapping is necessary, see paragraph e(1),
above.
(12)Install spring dowel into bottom of barrel, with
slot of pin to front of housing.
f.
Tachometer Drive Assembly
.
Repair
of
tachometer drive assembly is limited to general
maintenance
repair
procedures
(para.
2-7)
and
replacement of spared parts (appendix B).
g.
Fuel Pump Housing
.
(1) Perform general maintenance repair procedures
(para. 2-7) and replace defective spared parts (appendix
B).
NOTE
If replacement of front main shaft bushing (fig.
B-18) is necessary perform steps (2) through
(5).
(2) Drive out worn bushing using a gouge chisel and
mallet.
3-46


Back to Top