TM-9-2815-213-34
ENGINE, DIESEL, WITH ACCESSORIES CUMMINS MODEL V8-300 (2815-910-8217)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING DIRECT SUPPORT AND GENERAL SUPPORT REPAIR PARTS LIST AND DEPOT MAINTENANCE ALLOWANCES)
FEBRUARY 1972
TM-9-2815-213-34 - Page 58 of 192
*TM 9-2815-213-34
Figure 3-59.
Injector test stand
(2) Attach drain hose to tester base and place loose
end in test stand drain pan.
(3) Assemble 2 degree cup seat and space
to seat bracket bore.
(4) Check cup markings as shown in figure
3-57, for number of spray holes and place 6 and 9
hole target ring in base.
(5) Insert injector in injector adapter (2’ fig.
B-28) as shown in (fig.
3-65).
(6) Remove plunger assembly and spring from
injector.
(7) Select correct size plunger bore plug and rubber
seal and install in injector plunger bore
(8) Install the solid knurled plug (fig.
65) in the injector drain opening.
(9) Place injector in spray angle tester seat (fig.
3-
65) and adjust hold-down bracket to position required, then
tighten thumb screw.
Figure 3-61.
Hydraulic and air valves.
3-29
Back to Top
