TB-9-3950-253-13-P
PALLETIZED LOAD SYSTEM TRUCK, M1075 and M1075A1 (PLS) AND HEAVY EXPANDED MOBILITY TACTICAL TRUCK, M1120, M1120A2, AND M1120A4 (HEMTT), ENHANCED CONTAINER HANDLING UNIT (E-CHU)
TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2009
TB-9-3950-253-13-P - Page 548 of 704
TB 9-3950-253-13&P
Change 1
0052-38
0052
HEMTT SLIDER ASSEMBLY INSTALLATION
00052
NOTE
•
Hand tighten all bolts on installation. Reposition mounting blocks during slider assembly
installation.
•
Use original 1/4 in. and 1/2 in. spacers previously removed when installing new slider
assembly.
•
Perform steps 1 through 4 for both right and left sides.
1.
Place 1/2 in. spacer (Figure 36, Item 5) and 1/4 in. spacer (Figure 36, Item 6) on slider support bracket
(Figure 36, Item 4).
2. Place mounting block (
Figure 36
, Item 1) on slider support bracket (
Figure 36
, Item 4) with holes offset to
outside of vehicle, aligning holes in spacers and mounting block with holes in slider support bracket.
3. Apply thread adhesive to three bolts.
4.
Install three washers (
Figure 36
, Item 2) and bolts (
Figure 36
, Item 3) in slider support bracket (
Figure 36
, Item 4).
Figure 36.
HEMTT Slider Mounting Block Installation.
052
Table 3.
Parts List for HEMTT Slider Assembly Installation.
ITEM NO.
052
QTY
052
DESCRIPTION
052
PART NUMBER
052
Figure 36, Item 1
2
Mounting Block
112090401
Figure 36, Item 2
6
3/4 Washer
112080102
Figure 36, Item 3
6
3/4-10 x 2 Bolt
112079703
Figure 38, Item 1
1
Slider Assembly
111589501
Figure 38, Item 4
8
9/16 Washer
112080109
Figure 38, Item 5
8
9/16-12 x 2 Bolt
112079719
Back to Top
