TM-5-2350-377-14-P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)
TM-5-2350-377-14-P - Page 47 of 335
TM 5-2350-377-14&P
WIRING HARNESS AND CABLE REPAIR - continued
TYPICAL PLUG
DISASSEMBLY
a. Remove nut from shell assembly and slide back on cable.
b. Slide grommet back on cable.
c. Slide coupling nut off shell assembly.
b. Push contacts out through rear of insert with pin extractor.
e. Push insert out through rear of shell.
f.
Unsolder cable from contacts.
g. Remove coupling nut, grommet, and nut from cable.
ASSEMBLY
a. Slide nut over cable.
b. Slide grommet over cable leads.
c. Strip cable insulation equal to depth of solder wells of contacts.
d. Insert cable into solder wells of contacts and solder.
e. Push insert into shell from rear until seated.
Groove in insert must be aligned with guide in shell to ensure proper fit.
f.
Push contacts into insert from rear until seated.
g. Slide coupling nut onto shell assembly.
h. Push grommet down cable and over solder wells of contacts.
i.
Install nut on shell assembly.
0008 00-6
CABLE
GROMMET
CONTACTS
(PIN OR SOCKET)
GROOVE
SHELL
INSERT
COUPLING
NUT
NUT
0008 00
Back to Top
