TM-5-2350-377-14-P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)
TM-5-2350-377-14-P - Page 45 of 335
TM 5-2350-377-14&P
GENERAL REPAIR AND
CLEANING METHODS - continued
BLOCKING TRACK OR ROADWHEELS
WARNING
Block track or roadwheels when parking brake is released, steer unit brake levers are
disconnected, or when track is disconnected.
Vehicle can roll causing damage to
equipment, severe injury, or death to personnel.
NOTE
If blocks are not available, use timbers 12 to 18 inches high (30 to 46 cm).
a. Stop vehicle on hard, level surface.
Stop engine (TM 5-2350-262-10).
b. Place blocks or suitable material in front of track at No. 1 road wheel and between drive sprocket and No. 4 roadwheel
on each side of vehicle.
If track is disconnected, place blocks or suitable material directly against No. 1 and No.
4 roadwheels on each side of vehicle.
WIRING HARNESS AND CABLE REPAIR
This section contains instructions on repair of wiring harnesses and cables (leads).
Repair of wiring harnesses and cables
consists of replacement of defective connectors, shells, and terminals, or taping cut or worn insulation and exposed wire
conductors.
Pages 0008 00-5 through 0008 00-8 show exploded views of typical harness and cable connectors used
on the vehicle and give procedures for disassembly and assembly of connectors.
When soldering is required, procedures
in TB SIG 222 must be followed.
If multiple pin connectors are disassembled, tag or label all wires and cables to ensure
that correct connections are made at time of assembly.
0008 00-4
0008 00
PLACE
BLOCKS
HERE
PLACE
BLOCKS
HERE
Back to Top
