TM-5-2350-377-14-P
ARMORED COMBAT EARTHMOVER (ACE), M9
TECHNICAL MANUAL; OPERATOR'S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST) SUPPORTING THE HYDRAULIC BLADE FOLDER-TRACK TENSIONER (HBF-TT)
TM-5-2350-377-14-P - Page 46 of 335
TM 5-2350-377-14&P
WIRING HARNESS AND CABLE REPAIR - continued
TYPICAL PANEL MOUNTING RECEPTABLE
DISASSEMBLY
a. Remove nut from shell assembly and slide back on cable.
b. Push grommet back on cable.
c. Push contacts out through rear of insert with pin extractor.
d. Push insert out through rear of shell.
e. Unsolder cable leads from contacts.
f.
Remove grommet and nut from cable.
ASSEMBLY
a. Slide nut over cable.
b. Slide grommet over cable leads.
c. Strip cable insulation equal to depth of solder wells of contacts.
d. Insert cable into solder wells of contacts and solder.
e. Push insert into shell from rear until seated.
Groove in insert must be aligned with guide in shell to ensure proper
fit.
f.
Push contacts into insert from rear until seated.
g. Push grommet down cable and over solder wells of contacts.
h. Install nut on shell assembly.
0008 00-5
0008 00
CABLE
GROMMET
GROOVE
SHELL
INSERT
NUT
CONTACTS
(PIN OR SOCKET)
Back to Top
