TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 114 of 400
0018-12
TM 9-2320-283-13&P
0018
1
2
3
1
2
3
4
5
REAR-REAR AXLE COMPONENTS INSTALLATION – CONTINUED
WARNING
Two personnel are required to install drum on hub. Brake drum
weighs 85 lbs (39 kg). Failure to comply may result in injury to
personnel. Seek medical attention in the event of an injury.
34.
Carefully slide rear brake drum (figure 19, item 3) over wheel studs (figure 19, item 1) on rear hub
(figure 19, item 2).
35.
Repeat steps 30 through 34 for installation of opposite axle shaft and rear brake drum.
Figure 19. Installing Rear Brake Drums.
END OF TASK
FRONT AXLE COMPONENTS INSTALLATION
1.
Depress and rotate screw (figure 20, item 1) on slack adjuster (figure 20, item 5) until brake drum
(figure 20, item 3) can be rotated freely at both ends of front axle.
WARNING
Two personnel are required to remove drum from hub. Brake drum
weighs 85 lbs (39 kg). Failure to comply may result in injury to
personnel. Seek medical attention in the event of an injury.
NOTE
In order to remove brake drum, it may be necessary to strike the
drum with a hammer to free it from hub flange.
2.
Carefully slide brake drum (figure 20, item 3) off wheel studs (figure 20, item 2) and remove from hub
(figure 20, item 4) at both ends of front axle. Discard both front brake drums (figure 20, item 3).
Figure 20. Removing Front Brake Drum.
Back to Top
