TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 118 of 400
0018-16
TM 9-2320-283-13&P
0018
1 (BW801543)
2 (801534)
3
4
1
2
3 (W26681)
(W26764)
4
5 (PHM5023)
FRONT AXLE COMPONENTS INSTALLATION – CONTINUED
17.
Install new clamp sleeve (figure 26, item 2) and new wheel sensor (figure 26, item 1) on front top hole
of spindle and brake spider (figure 26, item 4). Slide wheel sensor (figure 26, item 1) approximately half
way in clamp sleeve (figure 26, item 2).
Figure 26. Installing Clamp Sleeve and Wheel Sensor.
18.
Measure and cut new bulk split loom (figure 27, item 5) to length of wheel sensor power cable
(figure 27, item 2), and install split loom (figure 27, item 5) on power cable (figure 27, item 2).
CAUTION
To protect wheel sensor power cable, ensure split loom is positioned
through enlarged hole in brake spider during installation. Failure to
comply may result in damage to equipment.
19.
Tape end of split loom (figure 27, item 5) to power cable at wheel sensor (figure 27, item 1) with
electrical tape, and secure split loom (figure 27, item 5) to camshaft bracket (figure 27, item 4) with two
new tie straps (figure 27, item 3).
20.
Repeat steps 15 through 19 for installation of new wheel sensor (figure 27, item 1) at opposite end of
front axle.
Figure 27. Installing Split Loom on Wheel Sensor Power Cable.
Back to Top
