TM-9-2320-283-13-P
ANTI-LOCK BRAKE SYSTEM (ABS) M915A1
TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
AUGUST 2012
TM-9-2320-283-13-P - Page 117 of 400
0018-15
TM 9-2320-283-13&P
0018
4
1
2
3
5
1 (GUNHF801K)
2 (000-008-01-01)
3 (GUNW109R)
(GUNW109L)
4 (GUN3710X)
HAMMER
WOOD BLOCK
Figure 24. Installing Wheel Studs and Front Tone Ring.
15.
Remove locknut, (figure 25, item 5), washer (figure 25, item 4), and screw (figure 25, item 3) from front
top hole (figure 25, item 1) in spindle and brake spider (figure 25, item 2). Discard locknut (figure 25,
item 5), washer (figure 25, item 4), and screw (figure 25, item 3).
WARNING
Metal shavings are sharp and may fly out during reaming operations.
Wear eye protection when enlarging hole with reamer. Failure to
comply may result in injury to personnel. Seek medical attention in
the event of an injury.
CAUTION
Protect spindle shaft when enlarging hole in brake spider and spindle.
Ensure all metal shavings are cleaned from spindle and brake spider.
Failure to comply may result in damage to equipment.
16.
Using 11/16 in. (17.5 mm) reamer, enlarge front top hole (figure 25, item 1) in spindle and brake spider
(figure 25, item 2).
Figure 25. Enlarging Hole in Brake Spider.
FRONT AXLE COMPONENTS INSTALLATION – CONTINUED
Back to Top
