TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 140 of 400

0018-38

TM 9-2320-283-13&P

0018

1 (W3152X6)

2

3 (W1468X10X12)

4 (W3350X12)

5

6

7 (W3750X12)

INSTALLATION OF ABS AIR LINES – CONTINUED

NOTE

Reducer bushing and adapter removed in step 34 are reused in steps

35 and 36.

35.

Install new tee (figure 57, item 7) on primary reservoir (figure 57, item 2), and install reducer bushing

(figure 57, item 6) and new elbow (figure 57, item 4) on tee (figure 57, item 7) as shown in figure 57.

36.

Install adapter (figure 57, item 5) on reducer bushing (figure 57, item 6), and install straight fitting

(figure 57, item 3) on elbow (figure 57, item 4).

37.

Install plug (figure 57, item 1) on primary reservoir (figure 57, item 2).

Figure 57. Installing Fittings on Primary Reservoir.

NOTE

The 3/8 in. (9.5 mm) green tubing between the brake treadle valve

and the primary reservoir is replaced with 5/8 in. (16 mm) green

tubing.

38.

Disconnect tubes (figure 58, items 5, 11, 14, 17, and 18) from adapter (figure 58, item 16) and elbows

(figure 58, items 1, 2, 4, 12, and 15). Cut off and discard tube (figure 58, item 11).

39.

Rotate double check valve (figure 58, item 3) 1/4 turn counterclockwise, and remove elbow

(figure 58, item 12) and reducer bushing (figure 58, item 10) from brake treadle valve (figure 58, item 6).