TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 135 of 400

0018-33

TM 9-2320-283-13&P

0018

1 (W1480X10)

2 (PHPFT-10BGRN100)

3

*

4

*

5

6

7 (001-020-19-37)

8

9 (W323102)

10

11 (W3220X8X6)

12

13 (PH207ACBH-8)

INSTALLATION OF ABS AIR LINES – CONTINUED

19.

Remove bolt (figure 50, item 5) and locknut (figure 50, item 9) from crossmember (figure 50, item 12)

and front left spacer (figure 50, item 8) located adjacent to primary reservoir (figure 50, item 6). Discard

locknut (figure 50, item 9).

20.

Install new left-front bulkhead fitting mount (figure 50, item 7) on crossmember (figure 50, item 12)

with bolt (figure 50, item 5) and new locknut (figure 50, item 9).

21.

Install new bulkhead fitting (figure 50, item 13) on bulkhead fitting mount (figure 50, item 7) with

lockwasher (figure 50, item 4) and new nut (figure 50, item 3).

22.

Install new elbow (figure 50, item 1) and new reducer bushing (figure 50, item 11) on bulkhead fitting

(figure 50, item 13).

23.

Install hose assembly (figure 50, item 10) on reducer bushing (figure 50, item 11).

24.

Cut and route new 24 in. (61 cm) piece of 5/8 in. (16 mm) green tubing (figure 50, item 2) between

left-front bulkhead and left-rear modulator, and connect tube (figure 50, item 2) to elbow

(figure 50, item 1).

*

ITEM 3 SUPPLIED WITH ITEM 13

*

ITEM 4 SUPPLIED WITH ITEM 13

Figure 50. Installing Left-Forward Bulkhead.