TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 477 of 779

Disassemble

1. Remove two retaining rings (A) from cross shaft

bracket.

2. Remove ball bearing (B) from brakcet.

3. Remove two ball bearings (C) from cross shaft lever.

4. Remove two retaining rings (D) from lever.

5. Loosen two nuts (E) and remove left and right rod end

bearings (F) from adjustable control rod.

Note.

The rod bearings (F) are pinned and are

not to be disassembled. Do not attempt t o

disassemble connecting link .

Assemble

1. Install left and right rod end bearings (F) in ad-

justable control rod and tighten nuts (E).

2. Install two retaining rings (D) in cross shaft lever.

3. Position two ball bearings (C) in lever.

4. Position ball bearing (B) in cross shaft bracket.

5. Install two retaining rings (A) in bracket.

Figure 6-220. Disassembling or assemblin g

cross shaft lever, bracket, and

adjustable control rod .

b. Cleaning.

Refer to paragraph 6-2 .

c. Inspection and Repair.

Refer to paragraph s

6-3 and 6-4 for procedures and table 6-36 fo r

overhaul standards.

6-18 3