TM-9-1200-215-34-P
AUTOMATIC FIRE CONTROL SYSTEM (AFCS)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
FEBRUARY 1999
TM-9-1200-215-34-P - Page 57 of 266
TM 9–1200–215–34&P
2–22
2–17.
TCIM CCA MAINTENANCE INSTRUCTIONS CONTINUED
b.
INSTALLATION
CAUTION
ESD SENSITIVE
The ACU contains ESD sensitive
components. Wear a protective
ESD wrist strap whenever handling
components. Failure to comply may
result in damage to equipment.
1.
Attach ESD grounding strap to wrist and
ground to ensure ESD protection.
2.
Install TCIM CCA (2) in connector J5 on
backplane (13) in ACU housing.
3.
Torque screw (5) in Loktainer of TCIM CCA (2)
to 25 in. oz.
4.
Connect card edge connector (12) to side of
TCIM CCA (2) and tighten two captive screws
(11).
5.
Insert screw (3) and flat washer (4) into
holddown of TCIM CCA (2).
Torque screws to
5 in.–lb (0.6 N
S
m).
6.
Connect SCSI cable connector (1) to TCIM
CCA (2).
CAUTION
The EMI shielding gasket is vital to
this piece of equipment and is easily
damaged.
Handle with care when
removing or replacing it.
Failure to
comply may result in damage to
equipment.
7.
If removed, install EMI shielding gasket (9) in
groove in housing (10).
8.
Position connector panel (6) on housing and
align holes.
1
5
3
4
6
9
2
13
11
12
10
Back to Top
