TM-9-2330-227-14-P

SEMITRAILER, VAN: SHOP, 6-TON, SINGLE AXLE, M146

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JUNE 1985

TM-9-2330-227-14-P - Page 130 of 576

TM 9-2330-227-14&P

4-52

SERVICE TAILLIGHT ASSEMBLIES

This task covers:

a. Removal (page 4-52)

c. Installation (page 4-54)

b. Lamp, Lens, and Door Assembly

Replacement (page 4-53)

INITIAL SETUP

Tools

Personnel Required

Handle, ratchet, 3/8-inch drive

One

Screwdriver, flat-tip, 3/16-inch

Socket, 3/8-inch drive, 9/16-inch

ACTION

LOCATION

ITEM

REMARKS

NOT E

Both service taillight assemblies are removed and installed, and lamp, lens and door

assemblies are replaced in the same way. These procedures are for one; repeat for

the other.

Tag wires to aid in installation page (4-4). If wire connectors are to be repaired or

replaced, go to wire connector procedure (page 4-71).

Removal is not necessary for lamp, lens, or door assembly replacement. If repairing

lamp, lens, or door assembly, go to step 4. If circuit marker bands are missing or not

readable, replace (page 4-73).

REMOVAL

CAUTION

Do not pull on wires, only pull connectors apart. Pulling on wires could damage them.

1.

Frame (1)

Six connectors (2)

Pull apart.

2.

Frame (1) and

Two screws (4) and

Using 9/16-inch socket and ratchet handle

service taillight

Iockwashers (5)

with 3/8-inch drive, unscrew and take out.

assembly (3)

3.

Frame (1)

Service taillight

Take off.

assembly (3)