TM-9-2330-342-23-P
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; FIELD MANUAL
OCTOBER 2012
TM-9-2330-342-23-P - Page 496 of 1348
GROUP II TERMINAL REPAIR - Continued
1
2
Figure 16.
Group II Terminal Assembly.
CAUTION
To prevent damage to individual wire strands, strip wire after placing it through seal.
2.
Strip end of wire (Figure 16, Item 2) leaving 0.25 in. (6.35 mm) of bare wire.
3.
Insert new terminal (Figure 17, Item 3) in locating hole of crimping tool using proper hole according to the
gauge of wire (Figure 17, Item 2).
1
2
3
4
CRIMPING TOOL
Figure 17.
Group II Terminal Assembly.
4.
Slide seal (Figure 17, Item 4) down to end of insulation (Figure 17, Item 1) on wire (Figure 17, Item 2).
NOTE
Wire and seal should be positioned so larger wings of terminal will crimp around seal and
smaller wings will crimp around exposed bare wire.
5.
Position wire (Figure 18, Item 3) on terminal (Figure 18, Item 2).
TM 9-2330-342-23&P
0055
0055-12
Back to Top
